Thingiverse
FlySky i6Xb Case
von Hachiro
54
Downloads
31
Likes
0
Makes
Simple case for FlySky's new radio receiver! (I printed in clear PLA)
It prints in two parts, and screws together using 2mm tapping screws.
I used 11mm length screws.
Takes about 25 minutes at .2mm resolution
Here's a 100 pack of 2mm screws on Amazon with prime shipping, if you need them ^-^
https://goo.gl/llvQvb
==Things to do==
-Make different versions for "only" PWM, i-bus, or PPM. As well as versions for each that cover the VBat plug, in case somebody wants that for some reason.
-Thicken the bottom half so the screws don't poke through
It prints in two parts, and screws together using 2mm tapping screws.
I used 11mm length screws.
Takes about 25 minutes at .2mm resolution
Here's a 100 pack of 2mm screws on Amazon with prime shipping, if you need them ^-^
https://goo.gl/llvQvb
==Things to do==
-Make different versions for "only" PWM, i-bus, or PPM. As well as versions for each that cover the VBat plug, in case somebody wants that for some reason.
-Thicken the bottom half so the screws don't poke through
Hachiro veröffentlicht auch auf
19 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
