Thingiverse
FlySky X6B receiver mount
18
Downloads
15
Likes
0
Makes
This is a mounting plate for the FlySky X6B receiver.
I used to simply attach the receiver PCB with 3M UHB tape.
I recently ran into a situation where I needed to remove the electronics from a model to perform some repairs. The tape did its job too well and I decided to re-mount the Rx so it could be removed more easily.
This part has recesses on the bottom for two M2 nuts. The Rx can be attached with 6mm or 8mm long M2 screws.
The standoffs are the same height as the connectors on the bottom side of the board so it sits very solidly.
I used to simply attach the receiver PCB with 3M UHB tape.
I recently ran into a situation where I needed to remove the electronics from a model to perform some repairs. The tape did its job too well and I decided to re-mount the Rx so it could be removed more easily.
This part has recesses on the bottom for two M2 nuts. The Rx can be attached with 6mm or 8mm long M2 screws.
The standoffs are the same height as the connectors on the bottom side of the board so it sits very solidly.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!