FM Brushless Motor Mount

NOT a Flite Test Motor Mount.

Version 2 added an opening for the wires to pass through.

I designed the Fly Mike Motor Mount to fit inside a 2" by 2" outer dim. R.L. Adamas foamboard crafted into tubes. Flite Test rocks, but I felt limited trying to work a power pod into all mt designs.This design fixed that issue for me. It has allowed me to mount my motor in any location I could make a housing for it.

Design has a 16mm by 19mm bolt pattern, and horizontal skewer holes (should fit most bamboo bbq skewers).

Note: I model knowing the limitations of my 3D printer. Its old and has a few minor quirks. In general its accurate but holes especially tend to print out smaller than they are sized in the model. As such I model holes slightly larger to accommodate this. Test print any part and make sure any attached hardware like wire or skewers fit properly before bulk printing.