FMS Viper 70 ceiling model holder

This design is intended to store the FMS (or equivalent) Viper 70 jet under the ceiling of your workshop, hangar of office.
The surfaces of the internal shape are protected using 3mm self-adhesive foam rubber. Please pay special attention that an additional layer is used in order to avoid any pressure of the holder on the flaps (see picture). Please use with motor batteries removed from the model only.
Outer distance between both holders to be installed is appr. 300mm.

Not to be used for commercial purposes (reprinting, selling prints or data).

Please use at own risk. No guarantee or warranty of damage to the model to due misuse, improper installation or wrong printing settings or material selection.