Thingiverse
FÖRNUFTIG COMMAND Strip Wall Mount
door cdashdashb
5
Downloads
7
Likes
0
Makes
Some Command strip wall mounts to hold the Ikea FÖRNUFTIG Air Purifier on a wall without making any holes, technically the weight is a bit much. Mine is mounted low to the ground with some additional velcro adhesive to make up for the Command strip weight limits. Mine has been holding for three days on an actively used door.
I've been using this purifier to blow filtered air into my bedroom as I sleep without blocking the doorway, without drilling holes into a door (Door are surprisingly expensive, and flimsy). This also avoids the issue of noise from outside disturbing my sleep, simply open another window elsewhere and blow it into your room!
To install, place two of the 3d printed strips into the purifier with adhesive stuck to them and oriented vertically, then remove the backing and place the purifier into the desired position firmly. Then once its placed, remove the purifier leaving the strips stuck to the wall, then firmly press the strips to the wall each for 30 seconds. I
I've been using this purifier to blow filtered air into my bedroom as I sleep without blocking the doorway, without drilling holes into a door (Door are surprisingly expensive, and flimsy). This also avoids the issue of noise from outside disturbing my sleep, simply open another window elsewhere and blow it into your room!
To install, place two of the 3d printed strips into the purifier with adhesive stuck to them and oriented vertically, then remove the backing and place the purifier into the desired position firmly. Then once its placed, remove the purifier leaving the strips stuck to the wall, then firmly press the strips to the wall each for 30 seconds. I
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
