Slicer Discord
fog light switchbox – 3D-Druckmodell von MakerWorld MakerWorld
Vehicles

fog light switchbox

3 Downloads
1 Likes
1 Makes
Zum Modell
pt cruisers with fog lights have an issue where the switch drains power even when everything is turned off.Chrysler sucks and their solution is to either buy a $200 replacement light controller (plus install), or remove the fuse that runs the fog light circuit. Forget that, instead I'm adding a fuse extender and a switch so I can turn them on at will. If this works well I'll probably bypass the the switch on the steering column and run entirely off of this, but for now there will be two switches in series. Switches used - https://www.aliexpress.com/item/1005007630181105.htmlFuse extender - https://www.aliexpress.com/item/1005005320045496.html 4/12/25 - added a magnet mounting bracket for the switch housing so I can just open the clam shell if needed.
Kategorie
Vehicles
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Nachbearbeitung
Hardware
Software
Cura, PrusaSlicer o. Ä.
Gleicher Designer, mehr Plattformen

unhooked veröffentlicht auch auf

189 zusätzliche Modelle auf 2 weiteren Plattformen

Verifiziert durch übereinstimmende Modelltitel über Plattformen hinweg.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen