Foger Vape Case

No more dropping your vape and having your battery break off and fly across the floor! Print settings: Layer height: 0.28mm Supports: None Walls: 3 The bridge on the top of the window is a bit long, so it might droop. I hit it with a torch for a second and press it up and you couldn't even tell. Some filaments print stiffer than others. The vape slides in at an angle above the side window opening. Removing the vape requires you to remove the same way, sometimes slightly bending the corner open. Pulling it sideways and up by the mouth piece is the easiest way. Modeled with OnShape. Note the CC license does not allow for resale of model file or physically printed case.