Foldable Ender 3 v2 Kit

This is a quick and easy solution to "flat pack" an Ender 3 V2 for storage and transportation.

It only requires:
- 2x M5 bolts
- 2x M5 washers
- 2x M5 wing nuts

Remove 4x gantry screws from the underside of the printer. I also had to remove the washers fitted to the 8x side screws to make them go all the way in. Slide side brackets into the aluminium extrusion rails from both sides. To make it even more compact, you can print the included "screen support" and fit the screen to the right hand side rail as shown in photos.

How to fold:

1. Disconnect Z axis motor ribbon cable.
2. Slide build plate half way towards the back.
3. Pull Z axis all the way up
4. Loosen wing nuts
5. Slide gantry backwards and fold down.
6. Tighten wing nuts again.

How to unfold:
1. Loosen wing nuts.
2. Slide gantry forward and back up in place.
3. Tighten wing nuts.
4. Reconnect Z axis ribbon cable.


If you have problems with the gantry stability when printing, you can add the unde