MakerWorld
Organizers
Zum Modell
FOLDABLE GUNPLA RUNNER STAND - HEX PATTERN
326
Downloads
60
Likes
217
Makes
Introducing the Foldable Print in Place Gunpla Runner Stand (a mouthful I know!). This is the Hex pattern version. Make sure to check out the plain pattern here: https://makerworld.com/en/models/250739#profileId-267023 If you want an A1 Mini version, head here: https://makerworld.com/en/models/961591#profileId-931606 Decided to give myself a bit of a challenge in designing something that's both print in place and with some form of hinge. The model was inspired by the MGEX Strike Freedom paper runner stand and consists of a simple hinge design based on Nokiri's ribbon fidget toy. There's a catch on the bottom of it to prevent it from opening/folding back out from gravity. When taking it off the build plate, grab each hinge and give it a slow bend to loosen each segment. Going hard off the bat may cause it to disconnect Make sure to follow my page for upcoming variants of this model, and please leave a comment and photo of your new prints!
UnchainedHobbies veröffentlicht auch auf
25 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!