Thingiverse
Foldable handle
von beerman_uk
29
Downloads
20
Likes
0
Makes
A friend wanted a foldable handle for a battery pack he had made for his fishing trips so I designed this for him.
I used 4mm metal rods I had cut to 1 inch in length to attach the handle. I was going to glue these in but the fit is so tight I just tapped these in with a hammer.
I printed it at 45% infill with PLA plus and it worked out great.
I used 4mm metal rods I had cut to 1 inch in length to attach the handle. I was going to glue these in but the fit is so tight I just tapped these in with a hammer.
I printed it at 45% infill with PLA plus and it worked out great.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
