Foldable phone stand

Folding phone holder, can be used for tablet as well. The teeth of the holder are raised high so that you can use the charging cable and are wide enough to use the phone in a case. I was inspired by the design of a similar holder from this site, I don't remember who, I couldn't find it later.
Can be customized as source in SCAD.
The parts were printed by ABS and PLA with a 0.4 nozzle and a 0.2 layer, supports are needed.
4 M3x20 screws are needed for assembly.
When printing, it fits on a 200*200 table.