Folding Box Printer Calibration Cube

The Folding Box Calibration Cube is specifically designed for testing and benchmarking 3D printers as well as a tool to help fine tune print settings. Print without supports and see what your printer can do and where it could improve. Design is based off of the Protolabs injection molded folding box. Need advice on your print? Upload a photo to the comments/community section of this page or tag me (@piraxchild) on twitter to get the 3d print community to help troubleshoot the cube to improve your prints. Issues I had Previously: Cr10 Tollerances too tight Fixed by adjusting bed, lowering x/y speed in S3D, first layer extrusion height to 115% & width to 95%. Minor surface pillowing/ lifting on first layer Fixed by adjusting bed, first layer extrusion height to 115% & width to 95%. Small Features Fixed by lowering Minimum extrusion length, upping perimeter overlap, & changing thinwall type to single extrusion fill. Retraction  Fixed in S3d by turning on w