Folger Tech Effector and Sensor Holder Remix

When changing to the E3D Lite6 hotend, I needed to adjust the size of the effector & sensor mount. Since the E3D lite6 hotend is shorter than the hotend supplied by folger tech, I needed to be able to move the proximity sensor further up & in order to miss the connecting rods had to shift it in 3mm also. I added the optional Fan tube for cooling that I remixed in openscad from this: http://www.thingiverse.com/thing:1378065 . I thought I might be able to get 2 fans on there, but was too tight a fit, so I used one of the fan connection points on the sensor mount to wire tie the hotend wires. I also did not have very good success with this cooling fan. My fan did not put out enough air & also the bracket broke. I left that in the design in case someone else wants to try it or improve on it. I might try another fan later.

The effector part has a slightly deeper arc cut in where the rod ends meet to allow more clearance for the proximity sensor. I also made the locknut holes open