Thingiverse
FolgerTech FT-5 Extruder Mount
door Dan3Dmaker
82
Downloads
31
Likes
1
Makes
(Rev.2) This is a design for the gantry on the Folgertech FT5. It consists of 2 pieces. One top section which includes the front and back as one assembly. Then the bottom which is the 2nd piece that is removable for easy assembly! It includes a mounting location for the BL touch. It is intended for use with the E3D V6 and Titan with a pancake stepper motor.
https://www.amazon.com/Bipolar-Motor-18Ncm-25-5oz-17HS10-0704S/dp/B01LESPDCQ/ref=sr_1_12?srs=11378673011&ie=UTF8&qid=1487103078&sr=8-12&keywords=Nema+17
(Full Size Nema 17 mount) Now there is this added version that will work with the full size 40mm long stepper motor.
They are intended to be printed on either their top or the side opposite of the BL Touch
mount.
If you do go with the 25mm body pancake stepper make sure to tune the voltage on the driver to a safe level. I am currently at 500 mv with A4988 Stepper Drivers. If you do not adjust the reference voltage down it may overheat the the new motor causing the
https://www.amazon.com/Bipolar-Motor-18Ncm-25-5oz-17HS10-0704S/dp/B01LESPDCQ/ref=sr_1_12?srs=11378673011&ie=UTF8&qid=1487103078&sr=8-12&keywords=Nema+17
(Full Size Nema 17 mount) Now there is this added version that will work with the full size 40mm long stepper motor.
They are intended to be printed on either their top or the side opposite of the BL Touch
mount.
If you do go with the 25mm body pancake stepper make sure to tune the voltage on the driver to a safe level. I am currently at 500 mv with A4988 Stepper Drivers. If you do not adjust the reference voltage down it may overheat the the new motor causing the
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
