Slicer Discord
Folgertech FT-6 18mm Inductive Prox Mount – 3D printable model from Thingiverse Thingiverse

Folgertech FT-6 18mm Inductive Prox Mount

by jph290
1 Downloads
1 Likes
0 Makes
Go to Model
This is a mount for the FT-6 Dual Extruder version. This allows you to mount an 18mm prox to the existing mounting holes for the bed level sensor. The sensor I used is this one from Amazon https://www.amazon.com/dp/B00FZVKEAU/ref=cm_sw_r_tw_dp_U_x_Yx3kEbQBN923B.

It is an 18mm round PNP Inductive Proximity Sensor that has an 8mm sensing range.

Note: The rated range of the sensor is based on ferric (iron) surfaces. An aluminum surface will only get you ~40% of that range. This sensor will work just fine with a piece of 3/32 in. plate glass on the aluminum bed. The sensor was provided with 24VDC, if you are using a lower voltage, results may vary.
Source
Thingiverse
What you need to print this: Beginner Low confidence
Why?
2 colors
Single piece 2 colors / AMS
Supports 1/3
Assembly 0/3
Settings 1/3
Bed size 0/3
Post-process 0/3
Printer
FDM / FFF
File format
STL
Material
PLA
Colors
2 (AMS/MMU recommended)
Software
Cura, PrusaSlicer, or similar
No ratings yet
No comments yet – be the first!
Feed Blog Slicer Cost Calculator Image Search Submit Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Add to Collection