Folgertech FT-6 noise reduction

SummaryThis is a kit to help with the noise in the parts in Ft-6 printsThe problem I ran into is that the Two motor breakout board for X axis seems to backfeedpower between the two motors and adds noise in the print and limits the speed This can cause you to have to have larger than necessary retracts that can lead to jamsmod requires a 5 driver board and Blinkingsun's Y carriage so you can run both X motorsindependently with the makerbot limit switch with m3 hardwareThe pulleys replace one belt clamp on each of the Y carriage to keep light pressure to damp belt vibrationusing Flange Ball Bearings 3x10x4mm and m3 hardwareAlso change X axis pulleys from smooth to 16 toothed onesPlease leave a comment after trying any of these mods-Did it help?-Did it fit your printer?-Was it a waste of time?-Was it the fix you needed?Print SettingsRafts: No Supports: Yes Resolution: .2 Infill: 25Filament: amazon PetgBlack