FolgerTech FT5 Aeroshuttle

This is a replacement shuttle for the FolgerTech FT5 printer. It's designed for the E3D Titan Aero extruder, so it's got nothing under the stepper motor, allowing for the max possible bed clearance. With a V6 heat block you get about 25mm space for a fan duct.

The fan duct I've included was designed to try to minimize disruption due to clips on the bed. It does lose a few mm on the X axis, but it's not too bad.

If you choose to use the part cooling fan, it was designed to fit with these fans:

https://www.amazon.com/gp/product/B00EL938E6/ref=oh_aui_detailpage_o07_s00?ie=UTF8&psc=1

The duct prints in 2 parts which have to get glued together. I use CA glue. I get a nice strong air flow out of this even without sealing the connection between fan and fan holder, though I do plan to put a bit of caulking there to fully seal it.

The order of putting things together is important:

Fan duct:
1: fan connects to fan holder
2: fan duct connects to fan holder
3: fan mount conn