Slicer Discord
Folgertech FT5 Extruder Mount – 3D-Druckmodell von Thingiverse Thingiverse

Folgertech FT5 Extruder Mount

von n23d
10 Downloads
2 Likes
0 Makes
Zum Modell
This is an extruder mount for the Folgertech FT5. It is wider so it can accommodate motor connector pass throughs for removing the extruder without disassembling the extruder mount. The wire drag chain mount has been moved to the left so it does not interfere with the bearing mount screws. An integrated belt clamp was added and moved to better align with the drive pulley and eliminate the need for wire ties. A lower set of extruder motor mounting holes were added for a 4 screw attachment for better rigidity. The top and bottom plate through holes were eliminated and replaced with alignment blades and through holes for a lower overall profile and better support when tightening the clamping screws. The lower profile gives more clearance to the print bed so more room for the part cooling duct that I will be adding. One version has screw pockets for the extruder motor mounting screws and the other does not. The one without screw pockets requires longer screws. Parts are recessed on the
Quelle
Thingiverse
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Nachbearbeitung
Hardware
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen