Thingiverse
Folgertech Kossel 2020 Mod
von brocklee777
332
Downloads
211
Likes
2
Makes
For those of you who have the Folgertech Kossel 2020 printer, you will be aggravated with the amount of play in the print head. Tightening the adjustment screw in the slider will take some of the play out of the assembly. However if you tighten it too much you will break the slider and or cause the nylon bearings to become angled. This outer plate fits right on your existing slider. Parts required for this mod are (3) 5mm X 30 Machine screws, (1) 3mm X 25 screw per tower. Printed with ABS and tapped large holes with a 5mm tap, small hole with a 3mm tap. If you want to put a nut on the end of the 5mm screws get 5mm X 35 machine screws.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!