Folgertech Prisa i3 Y endstop

After spending a while searching for a better Y endstop for my Folgertech-built Prusa i3, I settled on creating my own. It's made to house a 40mm long endstop switch board, and fits exactly where it needs to be, so that my extruder does not hit a clip on the other end. Also features a special cavity for connector solder pins.

Board is held with M1.7 screws. You might want to customize the size of the hole in the SCAD file, if you don't have screws as small (although there is not too much space to play with).

Mount snaps on to threaded rods, measured ~7.6mm in diameter, about 20mm apart.