Thingiverse
For Honor Poleaxe
von SadNarwhal
117
Downloads
107
Likes
1
Makes
I was asked if I could make the Lawbringer poleaxe from the For Honor video game by dylanwhopper on my Great Axe project. http://www.thingiverse.com/thing:2181579
Challenge accepted!
I've designed this to fit around a 1 foot 1" wooden dowel for all the top pieces and a 1 3/8" wooden dowel for the body. The length of the body is up to you but the in game model appears to be around 6 feet tall. You will have to adjust how the models are situated in your slicer of choice.
Print 2 copies of all the langet pieces and 6 copies of all the screws. The larger ones go on the axe head and the bottom langets. The smaller ones go on the top langets and the connector piece.
All the pieces should be glued together with either superglue or an epoxy.
EDIT 4/26/17 - I went a little overkill with the tolerances so now the cylinder pieces that touch the wood should fit much more snug. Also added A combined version of the butt pieces.
Challenge accepted!
I've designed this to fit around a 1 foot 1" wooden dowel for all the top pieces and a 1 3/8" wooden dowel for the body. The length of the body is up to you but the in game model appears to be around 6 feet tall. You will have to adjust how the models are situated in your slicer of choice.
Print 2 copies of all the langet pieces and 6 copies of all the screws. The larger ones go on the axe head and the bottom langets. The smaller ones go on the top langets and the connector piece.
All the pieces should be glued together with either superglue or an epoxy.
EDIT 4/26/17 - I went a little overkill with the tolerances so now the cylinder pieces that touch the wood should fit much more snug. Also added A combined version of the butt pieces.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
