Thingiverse
Ford SQUARE key cover
von snowy50
5
Downloads
3
Likes
0
Makes
Use TPU in this design, one side is bigger then the other so you can just slip it in
note: i didnt use support on mine since i know it was going to be a pain to remove, so my advice is to do the same, and ass some extra fans when you do that over hang or ramp your fan speed
note: i didnt use support on mine since i know it was going to be a pain to remove, so my advice is to do the same, and ass some extra fans when you do that over hang or ramp your fan speed
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
