Slicer Discord
Forearm Ruler Stencil – 3D-Druckmodell von Thingiverse Thingiverse

Forearm Ruler Stencil

1 Downloads
0 Likes
0 Makes
Zum Modell
This is a stencil for a 10cm ruler you can paint on your forearm:

Instructions:

Preparation: A fine point sharpie and 20 cm of masking tape.

1) Put a piece of masking tape at each end of the ruler
2) Place the ruler on your non-dominant forearm and hold it in place with the masking tape.
3) Use a fine tip pen or sharpie to draw the lines, guided by the stencil.

4) You can use the cm section, the inches section or both!
5) If you use a sharpie, you can easily remove the ink from your skin with a cloth damped in Isopropyl Alcohol.

Enjoy whatever DIY you do.

I got this idea from Adam Savage, but I didn't feel like tattooing the thing on my arm.

About the design:

- This is designed for the LEFT forearm, although it can be used on either arm.
- The reason why the half-centimiter marks are closer to the wrist, is because I've found that part of the skin stretches and contract less, allowing better precision.
- If you wear a wristwatch, you may use it to keep the ruler in place while
Quelle
Thingiverse
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Nachbearbeitung
Bemalen
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen