Thingiverse
Forest Dragon (No Support Needed)
von idolcrasher
2k
Downloads
1.2k
Likes
18
Makes
Here is dutchmogul's fierce Forest Dragon with a MeshMixer pylon support structure built in.
This will make the dragon easy to print, no added support structure needed.
The orange dragon you see above was printed by digitydogs. On his recommendation, I will be releasing a V2 of the 'no support dragon' with a little less support in some areas :)
This will make the dragon easy to print, no added support structure needed.
The orange dragon you see above was printed by digitydogs. On his recommendation, I will be releasing a V2 of the 'no support dragon' with a little less support in some areas :)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!