Thingiverse
Fork Mount for Quick Release Wheels
di Jonah-1903
39
Download
29
Likes
0
Makes
I designed this fork mount for storing my bikes in our van, for long trips. It should hold any bike with a quick release front wheel and a 100mm front fork width.
I printed this on my Ender 3, with cura. I used adaptive layers between 0.1mm and 0.3mm to reduce print time, but I'd recommend using a small resolution.
What you'll need:
-1x 14cm M6 Threaded rod
-2x M6 (10mm) Nut
-2x M6 Wingnut
-4x countersunk screw/bolt for mounting it to a surface.
Assembly:
Put the 2 nuts in the 2 gaps on top.
Screw the rod through the mount and the nuts leaving 2cm on both sides.
Slide on the protectors and screw on the whingnuts.
I hope you find this usefull!
I printed this on my Ender 3, with cura. I used adaptive layers between 0.1mm and 0.3mm to reduce print time, but I'd recommend using a small resolution.
What you'll need:
-1x 14cm M6 Threaded rod
-2x M6 (10mm) Nut
-2x M6 Wingnut
-4x countersunk screw/bolt for mounting it to a surface.
Assembly:
Put the 2 nuts in the 2 gaps on top.
Screw the rod through the mount and the nuts leaving 2cm on both sides.
Slide on the protectors and screw on the whingnuts.
I hope you find this usefull!
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
