Thingiverse
Formbot T-rex 2+ / 3 Octoprint Mount
por anmael
4
Descargas
3
Likes
0
Makes
This is to mount a raspberry pi 3 and 5" display on top of the t-rex 2+ / 3.
All parts print without support.
The mount sits on top of the t-rex and is secured by 2 bolts/t-nuts
The back cover is pretty thin and needs to flex slightly in order to snap in place. Use the little lock key to make the backplate sit properly flush with the front of the case.
I suggest plugging in the usb cables into the Pi / Display before mounting the mount on the t-rex, there is not a lot of space to do it after.
All parts print without support.
The mount sits on top of the t-rex and is secured by 2 bolts/t-nuts
The back cover is pretty thin and needs to flex slightly in order to snap in place. Use the little lock key to make the backplate sit properly flush with the front of the case.
I suggest plugging in the usb cables into the Pi / Display before mounting the mount on the t-rex, there is not a lot of space to do it after.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!