Thingiverse

FormD T1 Modified Power Button

von Exergist

2 Downloads

2 Likes

0 Makes

The power button PCB that came with my FormD T1 SW had an issue where the PCB's wire "glue" (probably for strain relief) interfered with the button when it was pressed. This design adds "notches" to the button so the interference is removed.

I also added a bit of material so that the button is less loose when installed in the T1. The NX *.prt file is provided if you want to customize the design further.

Note that I designed this to fit with the T1 SW v2, though it might work with other T1 versions (I haven't tested them).

You can find a replica of the stock push button [here] [1].

[1]: https://www.thingiverse.com/thing:5590921