fostex Th-x00 bracket

Remix to make it able to be used with the Fostex TH-X00.

To put it on you will have to open up the headphones by taking the ear cups off, unscrew the plate, then remove the C washers holding the old bracket on, then screw everything back together and put the earpad back on (be careful not to damage the wire while doing this, I did and had to replace the wire as well)

Afterwards, just unscrew the peg holding the bracket to the headband, then reuse the peg and screw (and optionally, the spring. I didn't use the spring) to attach the printed piece in the same way it was connected to the original (ensure it's rotated the right way, it can only rotate about 30 degrees once connected. After that, just slide the bracket over the top of the speaker housing and fit the spikes into the holes on the side of it.

Notes:
I didn't use the spring that is attached to begin with as it made it a massive pain to put it back together, and I was worried the extra pressure would cause the screw to