Fountain Pen Stand

This is a fountain pen holder made specifically for the "Open 3D Fountain Pen" by Zoidberg38 here on Thingverse (nice design btw!)
https://www.thingiverse.com/thing:2026499

I decided to print 4 of Ziodberg's pens and add different nibs (ExtraFine, Fine, Medium & Broad)- now I can pick what to write with based on whatever I feel like that day!

The holder will take any fountain pen with a diameter of less than 16MM (most fountain pens)- just pay attention to the size of the clip- that seems to be the limiting factor in most cases.

Make sure you use supports under the tubes & around the letters. I didn't try printing without them, but I'd be surprised if my Prusa Mini could lay the gaps. And be patient removing the supports- it's tough inside the letters and the letter "F" has minimal contact with the base.. I didn't have any problems, but I can see it being a potential issue if you're not careful.

Printed with PLA. I used .1mm detail at 40mm/s because I wanted the deta