Fountain With Lights

A little fun. I wanted to try a big print. This is a water feature made 240 mm wide to catch splash from the fountain and just fit on an MK3S print bed. The first smaller version I made got a little wet around the sides from splash. (Turns out the bigger version still splashes outside, but not as much.)

Custom designed to fit this water pump + LED light ring combo. https://smile.amazon.com/dp/B0088CSO28.

Also some 5/16 (8 mm) tubing https://smile.amazon.com/gp/product/B01CGVJ9QG

There's a 3 mm gap to hide the wire from the pump to the LED light ring. The power cord and tubing hide inside the fountain pillars on each side. Takes just 3 minutes to connect the pump and tubing. There is a hole in the back where the power cord comes out to connect to the transformer that comes with the pump.

Prints in a quick 36 hours. I used just a 2 inch wide a cluster of supports under the "table" edge just in the center-front area using Simplify 3D manual supports. The unsupported areas pri