Slicer Discord
Four tone whistle – 3D printable model from MakerWorld MakerWorld
Other Hobby & DIY

Four tone whistle

3 Downloads
0 Likes
0 Makes
Go to Model
all credit goes to SelfTaughtStu_472555 This whistle design was born from my experiment with a 3D-printed whistling bomb, intended to be dropped from a drone. I took inspiration from the "Whisbang RC whistling bombs" and created a body with four chambers, hoping each one would produce interesting sound during free fall. Unfortunately, even from a 500m drop, it didnt produce any sound. However, when used like a traditional whistle (blowing into it) it works and its very loud, so I redesigned it to be a whistle instead. Using the Spectroid Android app, I measured the frequencies and loudness of each tone. Based on spectrum analysis assisted by ChatGPT, the results are approximately: 2769 Hz at -34 dB 3393 Hz at -31 dB 4447 Hz at -25 dB 6211 Hz at -18 dB I wasn't even blowing very hard during the test, since the sound was already quite intense. With more forceful blowing, it could likely get much louder. While 6211Hz was technically the loudest in the spectrum (at -18 dB), it sounded low
Category
Other Hobby & DIY
Source
MakerWorld
Published
Updated
What you need to print this: Beginner Low confidence
Single piece
Supports 1/3
Assembly 0/3
Settings 1/3
Bed size 0/3
Post-process 0/3
Printer
FDM / FFF
File format
STL
Material
Software
Cura, PrusaSlicer, or similar
No ratings yet
No comments yet – be the first!

Similar Models

6 Suggestions
Feed Blog Slicer Cost Calculator Image Search Submit Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Add to Collection