Thingiverse
Fox Fidget Spinner
von adreamkrusher
20
Downloads
8
Likes
1
Makes
Designed around 0.2mm (should be able to slice to .1 just fine)
Print should be correct size at 100% but depending on filament and bed temp you may need to bump up to 102% to get the 608-ZZ bearings into place..
Slic3r didn't read this right.. Cura worked fine and also uploaded Gcode for Monoprice Mini so you can go right to printing.
Use any Spinner cap or bearing cap from other sources. Heres a link: http://www.thingiverse.com/thing:2083000/#files
Print should be correct size at 100% but depending on filament and bed temp you may need to bump up to 102% to get the 608-ZZ bearings into place..
Slic3r didn't read this right.. Cura worked fine and also uploaded Gcode for Monoprice Mini so you can go right to printing.
Use any Spinner cap or bearing cap from other sources. Heres a link: http://www.thingiverse.com/thing:2083000/#files
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
