Slicer Discord
FPS Aim Assist Laser Pointer Mount – 3D-Druckmodell von Thingiverse Thingiverse

FPS Aim Assist Laser Pointer Mount

3 Downloads
7 Likes
0 Makes
Zum Modell
If you hipfire worse than Stevie Wonder and find yourself celebrating going positive in a match then this might be perfect for you... I really don't know yet, I am going to try it out. I am absolutely sure that it will not hurt my K/D ratio but I need all the help I can get to fight off these basement-dwelling 12-year-old pros.

It basically is a mount that you can sit on your coffee table and aim the laser towards your TV (I did some Googling and verified these low power lasers will not hurt TVs LED, Plasma, Or OLED). So scope in, position the laser at cross arrows and I think that will be where you are shooting when hip firing.

A few notes:
Base & Main Arm - Nothing special to note about the base or the main arm they print fine and work regardless of the changes that are made on the other parts.

Secondary Arm - I scaled to 104% for a 16mm diameter laser. 100% was too tight, and 102% the laser would go in but it might not come back out.

The bolt/nut - https://www.th
Quelle
Thingiverse
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA, ABS
Nachbearbeitung
Hardware
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen