Slicer Discord
FPV 250/300 – 3D-printbaar model van Thingiverse Thingiverse

FPV 250/300

door Joinc
69 Downloads
54 Likes
0 Makes
Model downloaden
I have completely upgraded the r.250 FPV Quad by quadmodder. I fly my quad fast and crash hard. I was tired of the same parts breaking in the same locations. I also increased the width of the body so I could put all four ESCs on top of the bottom plate to protect them. The width addition brings this quad in at just under 300mm. I added a frame around the perimeter to reduce frame twist, I also added gussets to the screw holes that had the highest failure rate. The arms have been redesigned to maximize strength and reduce twist. I have not broken an arm since this modification.

I used to use PET to make this quad for increased strength and dimensional stability, but since I made these changes to the frame I have switched back to ABS. ABS prints just as well for me on my PowerSpec 3D Pro (OEM FlashForge Pro).
Bron
Thingiverse
Wat je nodig hebt om te printen: Gemiddeld Lage betrouwbaarheid
Eendelig Hardware nodig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 1/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
PLA, ABS
Nabewerking
Hardware
Software
Cura, PrusaSlicer of vergelijkbaar
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie