Thingiverse
FPV drone leg
von alonx9
1
Downloads
1
Likes
0
Makes
A Leg for FPV drones
This is a Leg for FPV drones, I made it to raise the drone a bit so when you lift off or land the bottom side of it doesn't contact the ground.
3D printing tips:
- Print in TPU so it will be flexible and not break.
- print it on its side.
- I used 15% infill
Attach it to the drone with a zip tie and the leg facing the inside.
This is a Leg for FPV drones, I made it to raise the drone a bit so when you lift off or land the bottom side of it doesn't contact the ground.
3D printing tips:
- Print in TPU so it will be flexible and not break.
- print it on its side.
- I used 15% infill
Attach it to the drone with a zip tie and the leg facing the inside.
alonx9 veröffentlicht auch auf
2 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
