Thingiverse
FPV Drone Stand
von mshtk
89
Downloads
154
Likes
0
Makes
A stand for FPV drones
====================
I could only test it with my Nazgul 5 (approx. 400g), but it should be able to handle larger quadcopters without any problems.
For easier printing, a two-part version is also included. The parts can then be joined and glued together. This also makes it easier to design new attachments.
The base should also be printable without supports. The support rods are 4.5cm apart.
====================
I could only test it with my Nazgul 5 (approx. 400g), but it should be able to handle larger quadcopters without any problems.
For easier printing, a two-part version is also included. The parts can then be joined and glued together. This also makes it easier to design new attachments.
The base should also be printable without supports. The support rods are 4.5cm apart.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
