Thingiverse
FPV Launch Pad
por dawen
9
Descargas
14
Likes
0
Makes
This is printed with PLA and 0.3 layer height. I used support touching build plate.
For the assembly a sharp knife should be used, to make it fit on the side, where the support was detached.
In the end everything is glued together to make it as strong as possible. On the top i placed some anti-slip mat (sorry for my english) with double sided tape.
For the assembly a sharp knife should be used, to make it fit on the side, where the support was detached.
In the end everything is glued together to make it as strong as possible. On the top i placed some anti-slip mat (sorry for my english) with double sided tape.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
