FPV Pan system

360 degree fpv pan system for RC planes. Utilizes a standard throw metal gear 9gram servo for control. You will need 6 4/40 3/8" screws and 2 8mm ID 'skateboard' bearings for the assembly. (ceramic bearings are preferred as they weigh less). You will also need a short piece of standard printer belt, and a small 'star' lock washer to be sandwiched between the pinion gear and camera shaft when screwing together with an M2 x 12mm screw. This allows for spacing and to ensure grip. Deck spacing can be adjusted by using spacers cut to length. The mount shaft has been updated with a 1/8" center hole to allow for the addition of a carbon dowel rod to be glued in internally length wise for strength. This design is a re-mix of https://www.thingiverse.com/thing:2746303 and uses --> part_4_belt_drive_gear from this design and also the pinion gear from this design--> https://www.thingiverse.com/thing:3010065
Runcam split case that the shaft is designed for can be found here--> https://www.thingive