FPV Pentagonal Race Gate

This is a simply racing gate tha intend to be easy to assembly and dissasembly.
I use 25mm electrical plastic tubes with 90cm which makes a gate with 145cm at the middle.
You can use tubes with shorter ou larger lenght but make shure that all have the same measures.
I post a photo with the reference of the tubes that I use. If you cannot find it, you can change que original file enclosed. This grey tubes has good characteristics to be outside with UV protection.

The gate has two diferent pieces. One has a base and a hole to attach a rod or some ropes if someone needs to hold on a tree trunk.

The other piece is simple, just to make the right angle.

I do some holes too to fit a bolt if the tube became loose.

Only use supports by touching build otherwise you will need to sand a lot inside the piece in order to fit the tube. I use PLA.