Thingiverse
FPV Quad Launch Stand
von marcnetic
30
Downloads
44
Likes
1
Makes
#FPV Quad Launch Stand!
Avoid liftoff from the dirt, on wet grass or in the snow with this highly practical, foldable print-in-place quad launch stand!
Nipples are 28 mm apart, so it fits only smaller quads (examples show a GepRC Phantom and a Cinelog25).
##Notes
This thing is designed for a layer height of 0.2mm and a nozzle width of 0.4mm. Horizontal distances of of the folding mechanism are 0.2mm while vertical ones are 0.4mm. This was an okay compromise between easy separation of the parts and a mechanism that is not too loose. This doesn't mean it won't work with different printer setups, I just didn't try.
Avoid liftoff from the dirt, on wet grass or in the snow with this highly practical, foldable print-in-place quad launch stand!
Nipples are 28 mm apart, so it fits only smaller quads (examples show a GepRC Phantom and a Cinelog25).
##Notes
This thing is designed for a layer height of 0.2mm and a nozzle width of 0.4mm. Horizontal distances of of the folding mechanism are 0.2mm while vertical ones are 0.4mm. This was an okay compromise between easy separation of the parts and a mechanism that is not too loose. This doesn't mean it won't work with different printer setups, I just didn't try.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
