FPV RC Plane

After seeing Joshua Cameron's Mini RC Wing: https://www.thingiverse.com/thing:2781182, I decided to use the same techniques to make a larger dual boom aircraft which would be able to carry FPV gear better and support more powerful power systems.

To print this model you will need the following 3D printed parts:
1x Left wing
1x Left Aileron
1x Right wing
1x Right Aileron
1x Horizontal stab
1x Elevator
1x Cockpit or FPV Cockpit
1x Fuselage front
1x Fuselage rear
2x Spar
2x Vert Stab

You will also need:
1x 1507 or similar motor
1x 15a ESC, dependent on your motor
3x 3.7g servos
1x RC Receiver
1x Servo extension for the elevator servo
1x 3in Triblade Prop
1x 4s 650mah LiPo


In order to keep the weight down, all parts (besides wings, control surfaces and stabilizers, more on that later) should be printed with only 2 perimeters and 2 top and bottom layers. Use 5-10% infill.

For the wings, control surfaces, and stabilizers you're going to print them with just