Thingiverse
FPV Whoop Camera Mounts
11
Downloads
5
Likes
0
Makes
These are FPV camera mounts that allow you to use a 12mm or 14mm with no screw mounts in a drone with screw mounts. They were designed to the Mobula canopy, but could work in other similar canopies.
The 12mm mount was specifically made for the Foxeer Pico Razor.
The 14mm mount will fit a number of cameras Like the Runcam Nano 3. The area between the tabs is It's 14mm and a bit to accommodate some of the boards I checked being cut weird with rough edges.
They are meant to be glued to the back of the camera. This is to prevent Jello that other clip on mounts can cause. I used e6000 glue.
Printed in PETG.
The 12mm mount was specifically made for the Foxeer Pico Razor.
The 14mm mount will fit a number of cameras Like the Runcam Nano 3. The area between the tabs is It's 14mm and a bit to accommodate some of the boards I checked being cut weird with rough edges.
They are meant to be glued to the back of the camera. This is to prevent Jello that other clip on mounts can cause. I used e6000 glue.
Printed in PETG.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
