Thingiverse
FR8 - Arm Cut Files
by jeffmhopkins
11
Downloads
10
Likes
0
Makes
Arm files to change an FR7 into an FR8.
Distance prop to prop is 0.45", distance prop to rear plate is 0.4", Field of view from front of plate to prop disc is reduced 10 degrees. Not sure yet on props in view from superview GoPros
V2 -> increased FOV to what the FR7 was to reduce prop in view
V3 -> Added center cutout for fastener mid plate
V4 -> Same ends as the FRH, only three motor holes... not tested ;)
Distance prop to prop is 0.45", distance prop to rear plate is 0.4", Field of view from front of plate to prop disc is reduced 10 degrees. Not sure yet on props in view from superview GoPros
V2 -> increased FOV to what the FR7 was to reduce prop in view
V3 -> Added center cutout for fastener mid plate
V4 -> Same ends as the FRH, only three motor holes... not tested ;)
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
