Thingiverse
Frame Braces
by Jarodirvin
22
Downloads
21
Likes
0
Makes
My frame was wobbly when printing at higher speeds so i made some braces to stiffen it up.
Be careful when mouting the motherboard. It leaves the back, bottom of the circuit board really close to the metal frame. I glued some rubber to the frame to make sure it does not ground out and ruin things.
The power supply spacers will be needed to mount the left hand brace.
I do not remeber the screw sizes I used and i think i had to drill out holes to make everything fit.
Be careful when mouting the motherboard. It leaves the back, bottom of the circuit board really close to the metal frame. I glued some rubber to the frame to make sure it does not ground out and ruin things.
The power supply spacers will be needed to mount the left hand brace.
I do not remeber the screw sizes I used and i think i had to drill out holes to make everything fit.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!