Framework Expansion Card Holder

This is an expansion card holder for framework laptops. This holds anything between 1 and 16 cards, depending on which one you print. Why you would print only a single size slot... perhaps testing? Print whatever size you want. I also included the source blender file for anyone wanting to make anything bigger, if it can fit on your bed.

There are 2 ways you can go about printing this. One is by printing a top and bottom of the same slot size. The other is by printing 2 bottom's of the same size.

If vertical space is an issue then I'd recommend going the top/bottom route.

If vertical space is not an issue for you, and you prefer utility, I recommend going the bottom/bottom route for a number of reasons.
1. The vertical space internally was explicitly designed to be able to fit the cards by combining 2 bottoms.
2. The USB-C gap also allows for you to be able put the cards in the upside-down configuration. This would allow for all 4 possible different directions, and they will