MakerWorld

Electronics

Franke galaxy 1000 corner replacement button

door Jami · Electronics

0 Downloads

0 Likes

0 Makes

The on/off button of our Franke Galaxy 1000 FX INOX broke off and got stuck on the “on” position so we couldn't turn it off again. I took the whole thing apart and there was only one replacement part I could find that cost well over 100€ so I decided to just design my own home button. It is being held by the frame, just like the original buttons, so no gluing or whatever needed. The corner button is different then the other row buttons! So if you need a row button you will have to slightly cut off the side. The only thing I would change is make the button slightly shorter (but not too short so it doesnt get stuck again like the original.) But it's a big pain to change it back out so… I printed it in white PETG but PLA should work too. Supports on and used 10% infill

franke extractor button replacement jami franke holding ag replacement part spare part power button switch button push button broken button fix repair instead of replace cost saving home maintenance appliance restoration front panel button

Categorie

Electronics

Bron

MakerWorld

Gepubliceerd

27.02.2026

Bijgewerkt

29.03.2026

Wat je nodig hebt om te printen: Beginner Lage betrouwbaarheid

Eendelig

Supports 1/3

Montage 0/3

Instellingen 1/3

Bedgrootte 0/3

Nabewerking 0/3

Printer

FDM / FFF

Bestandsformaat

STL

Materiaal

PLA, PETG

Software

Cura, PrusaSlicer of vergelijkbaar

Zelfde ontwerper, meer platforms

Jami publiceert ook op

2 extra modellen op 1 andere platforms

Printables

2 modellen

♥ 1 ↓ 12

Nog geen beoordelingen

Nog geen reacties – wees de eerste!

Vergelijkbare modellen

1 Suggesties

Franke galaxy 1000 corner replacement button

Vergelijkbare modellen

Toevoegen aan collectie