Thingiverse
Freaky Pumpkin
139
Downloads
151
Likes
0
Makes
Inspired by Megawillbot https://www.thingiverse.com/thing:3129886 but my own design.
Pumpkin spins to open up and expose the freaky pumpkin face.
Print Instructions
Right Eye, Left Eye, Teeth, Neck - 1 each - 0.16 layer height, no supports, print neck on triangular end.
Arms - 12 - 0.2 layer height, no supports, print on side so holes are horizontal
Core - 1 - 0.2 layer height, no supports, print with neck opening (triangle opening) down.
Base - 1 - 0.2 layer height, no supports
Slice - 6 - 0.2 layer height, print outside surface up with brim (or raft) and supports inside. Support the arm pivot extensions only on the very end. Support the arched surface but leave some clearance around the pivot arm extensions.
All of the slice and arm pivot joints are designed to pivot around filament hinge pins. The filament is inserted through the slice and core hinge holes and capture the hole in the arm. Use needle node pliers to flatten the filament pin on the outs
Pumpkin spins to open up and expose the freaky pumpkin face.
Print Instructions
Right Eye, Left Eye, Teeth, Neck - 1 each - 0.16 layer height, no supports, print neck on triangular end.
Arms - 12 - 0.2 layer height, no supports, print on side so holes are horizontal
Core - 1 - 0.2 layer height, no supports, print with neck opening (triangle opening) down.
Base - 1 - 0.2 layer height, no supports
Slice - 6 - 0.2 layer height, print outside surface up with brim (or raft) and supports inside. Support the arm pivot extensions only on the very end. Support the arched surface but leave some clearance around the pivot arm extensions.
All of the slice and arm pivot joints are designed to pivot around filament hinge pins. The filament is inserted through the slice and core hinge holes and capture the hole in the arm. Use needle node pliers to flatten the filament pin on the outs
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
