Thingiverse
Free-Standing Spool Holder
by ErnieC7772
1
Downloads
0
Likes
0
Makes
Holds standard roll spool.
Requires 4 roller bearings (6.5mm inner hole, 22mm outer diameter)
You'll need to print 4 copies of the frame and 2 copies of each support.
Minimum sanding and super glue required for assembly.
Assembly
Place 2 roller bearings between 2 Frame pieces. Connect with Short support at bottom center.(arrows pointing out toward frame pieces). Same for the other pieces.
Connect both assemblies with long support at either end.
Requires 4 roller bearings (6.5mm inner hole, 22mm outer diameter)
You'll need to print 4 copies of the frame and 2 copies of each support.
Minimum sanding and super glue required for assembly.
Assembly
Place 2 roller bearings between 2 Frame pieces. Connect with Short support at bottom center.(arrows pointing out toward frame pieces). Same for the other pieces.
Connect both assemblies with long support at either end.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!