FreeTouchDeck - modified case

A modified version of the original [FreeTouchDeck](https://www.thingiverse.com/thing:46610690) case by [Dustin Watts](https://www.thingiverse.com/dustinwatts/designs) with the following changes:

- reduced the angle of the screen from 45° to 30°
- reduces the overall size of the case.
- quicker to print
- no support required
- I prefer this angle as you push down more when tapping the screen so device is less likely to move across the desk
- replaced the screw holes in the case front with "pegs" that protrude through the screen's PCB rather than using screws
- also moved the pegs very slightly closer together (in the x-axis) to fit my board better
- replaced the hole in the side of the case that a USB cable could fit through with a smaller slot the size of a MicroUSB plug
- added mounting pegs for a MicroUSB breakout on the base of the case
- added 4 circular indentations in each corner of the underside of the base for sticking rubber feet

This is a remix from