Thingiverse
French Cleat Screwdriver Holder
von bunkw
79
Downloads
42
Likes
0
Makes
Simply print the racks and arms and snap them together to hang on a 3/4" cleat wall. I used supports on the racks but not the arms. Lay everything flat. I also made a stubby rack for the stubby drivers.
https://www.facebook.com/groups/704599717054448/permalink/787449448769474/
Enjoy!!
Update 12/1/20
I added hanger arms for a pegboard set up. Each leg is labeled L or R. Make sure when you snap it together the correct arms are on the side designated when looking at it as if it were hanging on the wall.
https://www.facebook.com/groups/704599717054448/permalink/787449448769474/
Enjoy!!
Update 12/1/20
I added hanger arms for a pegboard set up. Each leg is labeled L or R. Make sure when you snap it together the correct arms are on the side designated when looking at it as if it were hanging on the wall.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!